Risco-group ProSYS Version 8.xx Manual de usuario descargar pdf (Pagina 5)

ProSYS Version 8.xx - Supplementary Instructions 5

d. Press to confirm.

e. Repeat the above steps for other BUS detectors.

2. Assign the iWISE BUS detectors to a Zone:

a. From the main Engineer menu select [2] Zones > [1] One by One.

b. Select the zone number that you want to assign the BUS detector.

Note:

If you defined a virtual BUS Zone Expander, select a zone number from the virtual zones (defined

by the BUS Zone expander).

c. Define Partitions, Groups, Zone Type and Zone Sound.

d. In the Termination category, select [5] BUS Zone followed by

e. Select the BUS zone number to assign to the programmed zone. The type field

will be updated automatically when selecting the zone.

f. Press

. The loop response category is not applicable to a BUS zone.

g. Press

, assign a label and press .

3. If you want to use the extra wired zone input on the iWISE BUS detector:

a. Repeat steps a. – c. in step 2 above.

b. In the Termination category, select the relevant BUS Zone input termination:

[07] BUS Zone Input N/C

[08] BUS Zone Input EOL

[09] BUS Zone Input DEOL

[10] BUS Zone Input N/O

[11] BUS Zone Input TEOL

c. Press

. Select the BUS zone that the input zone belongs to. The Type field

will be updated automatically when selecting the zone.

d. Press

. Define the loop response time.

e. Press

, assign a label and press .

4. Configure the iWISE BUS detector parameters:

a. From the main Engineer menu select [2] Zones > [0] Miscellaneous > [3] BUS

Zone Parameters.

b. Select the zone that the BUS Zone was assigned to and press

c. Use the following tables to configure the parameters for the relevant iWISE BUS

detector.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Risco-group ProSYS Version 8.xx Manual de usuario Pagina 5