Risco-group WL Internal Rectangular Sounder Manual de usuario descargar pdf (Pagina 5)

Wireless Sounder Instructions 5

Mounting the Sounder

1. Open the front cover by removing the cover locking screw located at the bottom of the

unit.

2. Hold the back plate against the wall and mark the locations of the mounting holes.

Drill

the desired mounting holes and insert the screw anchors.

3. Mount the back unit to the wall using the supplied screws.

4. Insert the supplied batteries paying attention to the polarity.

5. Perform communication set up with the control panel.

6. Once communication setup is complete, close the cover and locking screw.

Remove cover

locking screw

Fixing Points to

Wall

Fig. 1 Fig. 2

Speaker Batteries

(6V, Serial

Connection)

Speaker

Reset

Switch

Two Indication

LEDs

Tamper

Radio Batteries

(3V, Parallel

Connection)

Fig. 3: Internal Sounder - PCB Diagram

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Risco-group WL Internal Rectangular Sounder Manual de usuario Pagina 5